In the current study, the additive manufacturing of nylon by fused deposition modeling is conducted based on statistical analysis. Besides, the aim of this study is the influence of process parameters, namely layer thickness (0.15 mm-0.35 mm), infill percentage (15-55%), and the number of contours (2-6) on the maximum failure load, parts weight, elongation at break, and build time. The experiment approach was used to optimize process parameters based on the statistical evaluates to reach the best objective function. The minimum value of build time and maximize of the failure load were considered as objective functions. The response surface method is regarded as an optimization process parameter, and optimum conditions were studied by experimental research to evaluate efficiency. Based on the results, the layer thickness is the significant primary variable for all responses. The experimental evaluation showed that the maximum values of failure load and elongation were obtained by changing the layer thickness from the lowest to the highest. By reduction in layer thickness at the same printing speed, the cooling rate increases, which results in greater strength and less elongation. As a result, it could be concluded that by increasing the number of contour layers from 2 to 6, the maximum failure force increased 42%. Increasing the contours due to the similar effect to increasing the infill density, increases the failure force and production time, which is also confirmed by the ANOVA.
